Antenna holder for mounting to Ubiquiti Unifi UAP-AC-M Mesh AP. This holds the included antennas at the recommended 45 degree angle and helps prevent weather, birds, etc. from pushing them out of position.
The holes are ellipses and not circular. This makes the holder tighter when it is pushed all the way over the antennas and they are tilted into place. You will only be able to slide this over the antennas if they are properly oriented before doing so.
Print with support to avoid the short gap at the bottom between the holes hanging too much. The 45 degree parts do not need any support. The infill percentage can be very low (20%), and hardly necessary at all.