This is a wall mount holder for a Milwaukee M12 3/8" Ratchet Wrench. Mount it to the wall with wood screws or drywall anchors. Insert the tool into the holder (it clicks into place) as shown in the picture below, with the face facing in and the light aligned with the notch. The tool holder has 3 countersunk holes for mounting, but I mounted mine with just the outer 2 with plaster anchors.See pictures below.Put the supports into the countersunk holes from the back with a small screwdriver or punch.
Update: I found that the PLA I made mine out of seemed to stretch out a bit over time and loosen its grip on the tool, not enough that it falls out, but looser than I like. So I added a strip of "gripper tape" from Lowes to the lower inside diameter and a few pieces of electrical tape to keep the edges of it from peeling up. A piece of the tape fits perfectly without trimming. See pics below. Do for a lot more.
The product was designed by
raylo32