This is an upgrade of the Lersta lamp from IKEA. Promising a clean and organised look, this wall mount comes with an included cable management system.
The cable clips are available on either the left or right side of the main component and can be customised to fit your needs exactly.
The included lamp base is easy to install using the included mounting hardware. Simply screw the included screws into the wall to hold the wall holder firmly, but leave enough space for the cable to slide into the cable routing channels. Remove the base of the lamp and slide the tube through the parts until the bottom of the tube is firmly in the bottom part. Now make sure to slide the cable into the cable routing channels and then fully tighten the screws.
To improve this setup even further, you can print this switch holder and use it to mount the dimmer switch on the wall. That way it will be in a fixed place and the cables will look neater than they would if the switch was just hanging around randomly
Contains 3 parts. A bottom clamp and 2 clamps to hold the lamp